Then, change your battery and factory reset the lock. If your Schlage BE365 Turn Lock feature is not working, check and enable the feature. You should get a new lock if your Schlage lock is rusty. As a result, rotating the thumb turn may not lock your door. If the Schlage Turn Lock feature doesn’t work after factory resetting the device, the thumb turn might be rusty or damaged. You can set new User Codes and try to lock the lock again to see if the Turn Lock feature is now active. You must complete this last step within 10 seconds. Then press and hold the Schlage button until a green light blinks from the button and your lock beeps. Now, re-insert your battery and replace the cover.Press the Schlage button and release it immediately.From the inside of your door, remove the battery cover.That said, follow these steps to factory reset your Schlage BE365:
#SCHLAGE BE365 MANUAL#
You can find the default Programming Code on the manual that came with the lock or on the back of the keypad assembly (this requires removing the lock from the door). So, you should reprogram the lock (add User Codes, change Programming Code, etc.) after the reset. Resetting the lock will also restore factory default settings on the lock. The next thing you want to do is factory reset the lock to fix unseen glitches preventing the Turn Lock feature from working. If your Schlage BE365 Turn Lock feature doesn’t work after you’ve tried the steps above, the lock might be malfunctioning. Your Schlage Turn Lock feature should work fine now. Ensure you only use non rechargeable alkaline batteries.Bolt the screws back onto the lock cover.Also, check that the lock cover is placed in the same position as it was when you removed it. Replace the lock cover, ensuring that you place the handle at the center.You’ll hear a beep once you insert the new 9-volt battery.Remove the battery from its compartment.This will reveal the 9-volt battery in the device.Next, detach the cover of the lock from the door.This is how you should place the lock when re-assembling it. Observe the side where the lock rotates to.On the interior assembly, remove the screws on the Schlage lock using a screwdriver.
#SCHLAGE BE365 HOW TO#
That said, here’s how to replace the batteries in your Schlage Lock: More so, if you have been using your Schlage Lock batteries for nearly three years, you might need to change the batteries if you notice any malfunction in the lock. Some malfunctions on the lock may indicate that the batteries are low. However, for some reasons, the batteries may run low unnoticed sometimes. How do you know if your batteries are dead? The lock will keep flashing red, meaning the batteries are low.
The Turn Lock feature in your Schlage lock may not work because your batteries are low.Īs you probably know, your Schlage BE365 runs on battery power, and some features may stop working if the batteries are low. If your Schlage BE365 doesn’t lock, continue to the next step. This means you have successfully enabled the Turn Lock feature on the lock.Īfter enabling the Turn Lock feature, press the Schlage button and rotate the thumb turn to lock your door.
0 kommentar(er)
